PVC Assembly Instructions | PVC Sign Kit Assembly

Lay post on floor, slot up.

Slide top corner of sign into post slot              (some pressure may be required.)

Rotate sign back in direction of arrow 1, while pushing sign forward.

Fit groove into slot.

As bottom of sign clears the post slot, rotate the sign into the post.

Slide the sign back into the sign groove in the direction of arrow 3. Sign is now locked into the post.

Rotate the post down in direction of arrow 4, while sliding the post in direction of arrow 5.

As the bottom of the sign clears the post, push the post over the sign in the direction of arrow 4.

Slide the sign back into the sign groove in the direction of arrow 6.

Install caps with silicone or PVC glue.